27
Ensure the saw is disconnected before completing the remainder of the
cleanup process.
Ensure water is not forced into the motor casing when cleaning.
NEW MAINTENANCE
Perform the following after initial purchase and operation of the MK-2000
MAINTENANCE FOLLOWING USE
To extend the life of the MK-2000, the following procedure should be performed after each use. Lubri-
cate all points listed below with light oils such as, 3 in 1, WD-40, etc.
(A)
Check and adjust belt tension fol-
lowing the rst 48 hours of operation
(See Belt Inspection page 30).
(A)
Turn OFF saw and remove Cutting
Table. Lubricate the Roller Wheels.
(B)
Lubricate the three Blade Guard
Pivot Points.
(C)
Lubricate the Cutting Head Pivot
Points.
MK-2000 ELECTRIC SAW MAINTENANCE
To Next Page
Loading...
