26
PUMP CLEANUP
Ensure the saw is disconnected before completing the remainder of the
cleanup process.
MK-2000 ELECTRIC SAW CLEANUP
CAUTION
(A)
Clean the Water Pump suction
of all debris.
(B)
Place the Water Pump in an ex-
ternal container. Run the MK-2000
until clear water is seen at the Blade
cooling ports (Approx. 1 minute).
Ensure water is not forced into the motor casing when cleaning.
(A)
Clean the Movable Cutting Table
Guide Rails.
(B)
Clean the Movable Cutting Table
Roller Wheels. Clean the remainder
of the MK-2000.
CUTTING TABLE CLEANUP
To Next Page
Loading...
