14
PRODUCT SPECIFICATIONS
Operated and used according to this manual, the MK-2000 Electric Saws will provide years of de-
pendable service.
The MK-2000 Electric Saws are engineered as portable brick saws powered by either a 1-1/2 or 2
horsepower electric motor. The saw is capable of cutting masonry up to ve (5) inches (127 mm) in
height, sixteen (16) inches in length in a single pass.
Motor specications for the MK-2000 Electric Saw are listed below.
Model MK-2001SV MK-2002
Horse Power 1.5 hp 2.0 hp
Amps 14.4 16.8/8.4
Voltage/Gas 115V 115V / 230V
Overall Amperage 14.4 16.8 a / 8.4 a
Motor RPM 1725 3450
Blade RPM 2540 3100
Weight 157 lbs. 163 lbs
Part # 161195 150598
The motor is protected by a thermal overload equipped with a manual reset.
The MK-2000 Electric Saw is designed for use with a 14-inch diameter segmented wet or dry MK
Diamond blade with a .110 to .375 inch cutting width.
The MK-2000 Electric Saw can cut a variety of masonry types including, cinder block, slump stone
block, wall brick, paver brick, concrete block and cylinders, roong tile, marble, granite, decorative
rock or almost any other non-ferrous material.
NOTE: The MK-2000 Electric Saw is not designed to cut plastic or metals.
The MK-2000 Electric Saw is designed with a spring-assisted cutting head to allow for easier step
cutting. The Cutting Head can be locked in the down position when cutting smaller pieces.
MK-2000 ELECTRIC SAW PRODUCT SPECIFICATIONS
NOTE: The MK-2000 series is also available with a 50hz motor.
GENERAL DESCRIPTION
MOTOR SPECIFICATIONS
THERMAL OVERLOAD PROTECTION
BLADE CAPACITY
MASONRY TYPES
SPRING ASSISTED CUTTING HEAD
To Next Page
Loading...
