16
MK-2000 ELECTRIC SAW ASSEMBLY
ASSEMBLY (Optional)
(A )
Open the stand and place
it on at surface.
If using the MK Diamond Stand, follow these steps.
MOVABLE CUTTING TABLE INSTALLATION
(A)
While holding the front, position
movable Cutting Table roller wheels
above Guide Rails.
(B)
Seat movable Cutting Table roller
wheels on saw Guide Rails.
(C)
Verify movable Cutting Table is
seated correctly by moving table
back and forth
(B)
Set saw on stand as
shown.
(C)
Ensure pins are placed
through holes on frame.
NOTE:
To Next Page
Loading...
