EVA 3 Plus: Device User Manual
fluid.
4. Do not use strong detergents or alcohol under any circumstances for
optics cleaning. This would lead to irrevocable damage to the
optically-coated lens surfaces.
5. To limit contamination, use recommended disinfectant agents between
each exam.
6. Do not use corrosive materials or strong cleaning materials other than
those specifically prescribed on the casings or on the optics. Such
materials lead to permanent damage of the painted surface of your
colposcope and/or scratch the lens coatings of the optics. This leads to
considerable loss of quality of the entire visual system.
7. The EVA System was built to be resilient, but needs to be taken care
of like any other electronic device. It should never be stored or
operated in areas where it could get wet or could be exposed to
environmental conditions such as extreme temperature or humidity,
prolonged direct sunlight, dust, etc.
8. If the LED light ceases to work, due to battery drain or LED burn out,
stop using the colposcope and recharge the batteries. Sometimes a
discharged battery will manifest via a flickering LED. In this case,
recharge the battery to full capacity before continuing use.
9. No modification of this equipment is recommended.
1.9. Product Overview
Before use of your colposcope, check for damage on the outside of the
transport packaging, the optical unit, mobile device, and any accessories.
The following chapters provide step-by-step instructions for the testing,
installation, operation, and security references.
11
To Next Page
Loading...