Mobius Trimmer M108S - Page 42

MOBIUSTRIMMER.COM
MOBIUS PART RECOMMENDED PH
RANGE OF CLEANER
RECOMMENDED
CLEANER(S)
RECOMMENDED CLEANING PROCEDURE
SEPARATOR HOUSING
FAN HOUSING
(Anodized Aluminum Versions)
8.5 – 10 STEP 1 - CLEAN
- Tub O’ Towels Heavy Duty
Cleaning Wipes and/or
- RESIN8 XTRA
STEP 2 - RINSE
with water
STEP 3 - SANITIZE, IF
NECESSARY
- Shyield or Isopropyl
Spray with diluted cleaning solution, let sit for 5 – 10
minutes, brush/wipe down any areas with signicant
resin build-up then rinse. Pressure washer OK.
LID SCREENS
BLUE TUMBLER RETAINING RINGS
8.5 – 10 STEP 1 - CLEAN
- Tub O’ Towels Heavy Duty
Cleaning Wipes and/or
- RESIN8 XTRA
STEP 2 - RINSE
with water
STEP 3 - SANITIZE, IF
NECESSARY
- Shyield or Isopropyl
Spray with diluted cleaning solution, let sit for 5 – 15
minutes, brush/wipe down areas with signicant resin
build-up then rinse. Pressure washer OK.
MOBIUS BODY & LID 8.5 – 10 STEP 1 - CLEAN
- Tub O’ Towels Heavy Duty
Cleaning Wipes and/or
- RESIN8 XTRA
STEP 2 - RINSE
with water
STEP 3 - SANITIZE, IF
NECESSARY
- Shyield or Isopropyl
Spray areas that require cleaning with diluted cleaning
solution. Allow cleaner to sit for 5 – 10 minutes, then
wipe down with a cleaning wipe or soft cloth. For areas
with signicant resin buildup, a plastic razor blade
can be used to scrape off resin before wiping down.
Note 1: Do not pressure wash Mobius body and
avoid spraying control panel and other electrical
components.
Note 2: Use compressed air to blow down gears and
belts on left side of machine.