Mocka Vigo Desk - Page 2

1
2
Bring together the legs of the desk and attach the support beam with 2x
screws (B1). Tighten with a screwdriver. Attach 4x foot pads (J) to the
base of the legs.
Arrange the cross bracing rods in the position shown above. In the
centre of the cross bracing, attach the two rods together using 1x bolt (G)
and 1x capped nut (H).
B1
J
J
J
J
B1
GH
Vigo Desk
2
mocka.co.nz | mocka.com.au
Assembly Instructions