RESIN REGENERATION CYCLE
With a frequency programmed based on set water hardness, device automatically
regenerates resins during the following cycles: "Disinf. 90°C", "Washing", "D1 Custom", "D2
Custom" and "W1 Custom".
In any case, the first time thermo-disinfector is used or after a period of inactivity exceeding
24 hours, it is recommended to manually run a "Resin Regeneration" cycle.
Set the device as explained in FIRST START-UP chapter and press the button shown in the
figure.
At the end of regeneration process the following screen appears and the device is ready to
be used.
To Next Page
Loading...
