SYSTEM RESET
The system can be reset in two alternative ways, depending on the type of alarm occurred
(see the List of alarm codes below in this appendix):
a) Pressing the OK button.
b) Following the instructions displayed and holding down the RESET button for about 3
seconds:
1) Error Code
2) Error Description
Once alarm procedure is completed, the indication of the following image is displayed.
Pressing the RESET button for 3 seconds, the door is released and the device goes back to
the initial menu.
After the RESET and any technical operation necessary to eliminate the fault, the device will
be ready to perform a new programme.
NEVER TURN OFF THE DEVICE BEFORE CARRYING OUT THE RESET.
IF THE PROBLEM NEEDS THE INTERVENTION OF AN AUTHORIZED
TECHNICIAN, AFTER THE RESET TURN OFF THE DEVICE AND CLOSE
THE MAINS WATER TAP.
To Next Page
Loading...
