38
Display Operating Procedure
Description
In this position, the module is in standby
mode. When in standby mode, all
operations function as normal, but
no power is applied to the heating
elements. This mode is used for priming
the system upon installation, and can
also be useful for some diagnostic
applications.
Start Up Procedures
Turning the Espresso
Machine On -Standby Mode
1
Turn the Main Switch to the 1 position.
OFF 00:00
2
The message shown to the left will be displayed when the espresso machine is switched on.
NOTE: Ensure all air is removed from the group prior to staring the espresso machine.
This only needs to be completed once during the initial setup or when water is drained from the coffee boiler.
Instructions for bleeding the groups of air can be found in the Installation Guide.
HAZARDOUS VOLTAGE DISCONNECT FROM POWER
SUPPLY BEFORE SERVICING
WARNING
To Next Page
Loading...
