modbar av Series - Accessing Programming Mode

EN
41
Display
Operating Procedure
Description
Accessing Programming Mode
• To change the values of any parameter
the operator must rst enter into the
programming mode.
• There are two levels within the
programming mode that allow the
programming of specic parameters.
• The two programming levels are as
follows:
• Barista Programming - The parameters
contained within this level are ones
the operator can change to affect the
quality of the espresso.
No password is required for access.
Programming Mode
GH█ 105.0°C G1
OT█ 95.5°C 0.0
G1█ MODBAR G2█
163Puls 0Puls
1
Barista” Programming Level
While the espresso machine is on, press and hold the button T3 . After approximately 5 seconds the
following display appears.
Group Dose
Settings
2
This is the “Barista” programming level. To program the brewing amount for each button, to set the coffee
boilers, the pre-infusion, and to enable/disable the resistance.
E xit
Menu
3
To exit the programming mode, scroll to the exit menu, using the buttons T1 or T2 . Press the T3
button to conrm the exit, or press at the same time the buttons T2 and T3.