modbar av Series - Page 80

EN
80
Display Operating Procedure
Description
“Technical” Programming
Enter Password
1
After accessing the “Technical” programming menu and entering the password, use the buttons T1 and T2
until the following screen is displayed.
Group Dose
Settings
2
Move between the parameters using the buttons T1 or T2 until the display shows:
Group 1 Dose
Settings
3
Press the T3 button to start the doses programming procedure.
G1 Dose Mode
DOSE
4
Press the T3 button to access the menu, then navigate using T1 and T2 to choose between PULSES,
MASS and BREWRATIO, press the T3 button to conrm the option.
• This parameter allows the operator to
program the amount of coffee (brewing
amount) for each Selection Indicator.
• The brewing amount can be set in terms
of time (sec.), pulses, mass or brewratio.
• Once programmed, the Selection
Indicator remains lighted.
• It is possible to set the dose for both
a short and a long shot on the same
Selection Indicator.
• PULSE mode: control of doses in volume
• MASS mode: control of doses in mass
• BREW RATIO mode: ratio between the
coffee powder and the weight of the
drink
Program Dose
Group Dose
Settings
Group 1 Dose
Settings
(only on ABR espresso machine models)