modec MC89 - Transporting the Actuator; Storing the Actuator; Protecting the Environment

7
In certain circumstances, the tool may keep rotating for several seconds after releasing the
switch. Never put your hands close to the tool or any moving parts.
 Keep the ventilation slits on the actuator and the batteries free and clean to ensure adequate
cooling.
 Keep the contacts on the machine, charger and battery pack clean.
 Don’t open the battery. Risk of short-circuiting.
 Protect the battery from heat, for example direct exposure to the sun, to
fire, to water and to humidity. There is a risk of explosion.
 In case of damage or non-conforming use of the battery, vapors could
escape. Ventilate the work place and consult a doctor if you feel unwell.
a. Transporting the actuator
 Keep the original casing for return in case of any revisions or repairs.
 When packing, make sure that all switches are off and without any constraints.
 Always pack the tools in the correct spaces to avoid them knocking against each other.
 Replace the batteries in their allotted casing.
 Lithium-ion batteries are subject to rules regulating the transport of dangerous materials.
The operator can transport the batteries by road without taking any additional measures.
 When transporting via a third party (for example, by air or a via a transport company), you
must conform to the specific measures regarding packaging and labelling. In such a case,
it is imperative to take advice from an expert in the transport of dangerous materials
when preparing the transportation. Only send the batteries if the packaging is not
damaged. Recover any unprotected contacts and pack the batteries tightly so they
cannot move about. Please also follow any additional regulations that may apply.
b. Storing the actuator
modec actuators must be stored in a dry and correctly ventilated environment to ensure there
is no corrosion of the internal mechanic parts.
c. Protecting the environment
To eliminate waste, conform to the stated national requirements. The
actuators and their accessories must not be thrown in a waste bin.
Make sure you dispose of the tools in specialist recycling centers.