English 35
2. Adjustment of machine feet
- For a quiet and stable operation, put the washing machine on a
flat floor surface.
- The washing machine is equipped with engine legs that can be
adjusted height. Iffloor surface not flat, loosen the nut / nut and
legs manually (by hand) and adjust the height of the foot (2) up to
the machine in a stable condition.
- Do not use the tool when loosening the nut / nut as this may
damage the nuts / nut.
- After the washing machine in a stable condition, tighten the
back nuts / nut contained on washing machine foot.
3. Connecting to the water
c) Water channel entry
- Turn on the water faucet and let the water flow for a few
minutes until the water looks clear. (This is special run if you
use the new water system or for those who do not use the
water for long periods of time).
- Connect the water hose to water ingress hole located at the
rear of the machine.
- Make sure the other end of the hose is
securely attached to the tap water.
- Water drain hose should be placed at a height
of between 40 cm and not more than 100 cm
from the floor.
- Connect the water drain hose directly into
drains or if the water system has no direct
discharge, connect the drain hose to the sink.
- Put the drain hose along 15 cm into the sewer.
- Overall hose length is 3.2 m (max)
- Ensure that hoses are not squashed.
- Please use the new hoses to your new
washing machine.
To Next Page
Loading...
