English 45
once again, time delay function will be canceled. Press Start / Pause button. Previous time
delay time light turns off and next time delay time light turns on after every 3 hours. At the end
of the countdown, all time delay lights will turn off and the selected programme will start.
Note: Additional laundry may be loaded during the time delay period.
- Changing the time delay period
Press time delay button. Every time the button is pressed, the period will change in 3-hour
increments and the light of the selected time delay time will turn on.
- Canceling the time delay Start function
If you want to cancel the time delay countdown and start the programme immediately:
Set the time delay period to zero (all time delay period lights will turn off) or turn the
Programme Selection knob to any programme. Thus, time delay function will be canceled.
The End/Cancel light flashes continuously. Then, select the programme you want to run
again. Press Start / Pause button to start the programme.
- Starting the programme
Press Start / Pause button to start the programme. Programme follow-up light showing the
startup of the programme will turn on.
Note : If no programme is started or no key is pressed within 1 minute during programme
selection process, the machine will switch to Pause mode and the illumination level of the
temperature, speed and loading door indicator lights will decrease. Other indicator lights
and indicators will turn off. Once the Programme Selection knob is rotated or any button is
pressed,indicator lights and indicators will turn on again.
- Child Lock
Use child lock function to prevent children from tampering with the machine. Thus you can
avoid any changes in a running programme. Washer door will lock while it is in operation or
when not in use / power off. Throughout the program does not function unless the On / Off,
with On / Off button you can turn off or restart (when Child-lock active) other programs. To
activate the child-lock mode press the quick-wash and anti-creasing for 3 seconds, to disable
press the same button for 3 seconds.
- To activate the Child Lock:
Press and hold quick-wash button and pre wash button for 3 seconds. “The Indicator appears
on the display.
- To deactivate the Child Lock
Press and hold quick-wash button and pre-wash button for 3 seconds while any programme is
running. The lights on the 1st and 2nd Auxiliary Function buttons will flash while you keep the
buttons pressed for 3 seconds
When the power is restored after a power failure or after your machine is unplugged and
plugged in again, the Child Lock will not be deactivated when the machine resumes operating.
- Progress of programme
Progress of a running programme can be followed from the Programme Follow-up indicator.
At the beginning of every programme step, the relevant indicator light will turn on and light of
the completed step will turn off. You can change the auxiliary functions, speed and
temperature settings without stopping the programme flow while the programme is running.
To do this, the change you are going to make must be in a step after the running programme
step. If the change is not compatible, relevant lights will flash for 3 times.
Attention!
If the machine does not pass to the spinning step, Rinse Hold function might be active or
the automatic unbalanced load detection system might be activated due to the
unbalanced distribution of the laundry in the machine.
- Loading door lock
There is a locking system on the loading door of the machine that prevents opening of the
door in cases when the water level is unsuitable. Loading door light will start flashing when
the machine is switched to Pause mode. Machine checks the level of the water inside. If the
To Next Page
Loading...
