English 41
2. Select the wash program by turning PROGRAM knob.
3. Set the spin speed and other program extra if desired.
4. Press the START / PAUSE / CANCEL, to start the program.
5. Related symbols according to the program selected (symbol start, door loock, etc.) will appear
on the display screen.
Progress of programme
Progress of a running programme is indicated on the display with a set of symbols.
Relevant symbol appears on the display at the beginning of each programme step and all symbols
remain lit at the end of the programme. The farthermost right symbol indicates the current programme
step.
Prewash
If the Prewash auxiliary function is selected, Prewash symbol appears on the display indicating that
the prewash step has started.
Main Wash
Main Wash symbol indicating that the main wash step has started appears on the display.
Rinse
Rinse symbol indicating that the rinsing step has started appears on the display.
Softener
Softener symbol indicating that the softener step has started appears on the display.
Spin
Appears at the beginning of the final spin step and remains lit during Spin and Pump special
programmes.
- Changing the washing program
To change the washing program that has been running with a new washing program choices, you
can perform the following steps:
1.Press and hold for 3 seconds the "START / PAUSE / CANCEL" button to stop / undo the
previous program (eg "Cotton 60 ° C").
2.Turn the program selection knob to the desired position of the new program (eg "Cotton 40 ° C")
3.Then press the "START / PAUSE / CANCEL" to start the program.
- Adding or taking out laundry
Press the Start / Pause / Cancel button to switch the machine to pause mode. The programme
follow-up light of the relevant step during which the machine was switched into the pause mode
will flash. Wait until the Loading Door can be opened. Open the Loading Door and add or take out
the laundry. Close the Loading Door. Make changes in auxiliary functions, temperature and
speed settings if necessary. Press Start / Pause / Cancel button to start the machine.
Attention!
The loading door will not open if the water temperature in the machine is high or the water level
is above the door opening.
- Child lock
Use Child Lock function to prevent children from tampering with the machine. Washer door will
lock while it is in operation or when not in use / power off. Throughout the program does not
function unless the On / Off, with On / Off button you can turn off or restart (when Child-lock
active) other programs. To activate the child-lock mode press the quick-wash and anti-creasing for
3 seconds, to disable press the same button for 3 seconds.
- Door Lock
When the door is locked the lock symbol appears on the display, do not open the door by force
Attention!
If the engine is not running the process of "Spin" perhaps the "Rinse hold" function is on or
caused by an excessive load of laundry and an unbalanced distribution of the laundry in
the tube.
To Next Page
Loading...
