English 51
Program cannot be
started or selected.
- Machine may have switched to self protection mode due to an
infrastrcture problem(such as line voltage, water pressure, etc).
Reset your machine by pressing ’Start/pause’button for 3 second.
There is water coming
from the bottom of the
machine.
- Some water might have remained in the product due to the
quality control processes in the production.
This is not a fault, the water is not harmful to the machine
- Machine might be standing unbalanced.
Adjust the feet to level the machine.
- A hard substance might have entered into the pump filter.
Clean the pump filter.
- Transportation safety bolts are not removed.
Remove the transportation safety bolts.
- Laundry quantity in the machine might be too little.
Add more laundry to the machine.
- Machine might be overloaded with laundry
Take out some of the laundry from the machine or distribute
the load.
by hand to balance it homogenously in the machine.
- Machine might be leaning on a rigid item.
Make sure that the machine is not leaning on anything.
Machine stopped
shortly after the
programme started.
- Machine might have stopped temporarily due to low voltage.
It will resume running when the voltage restores to the normal
level.
Programme time does
not countdown. (On
models with display)
- Timer may stop during water intake.
Timer indicator will not countdown until the machine takes in
adequate amount of water. The machine will wait until there is
sufficient amount of water to avoid poor washing results due to
lack of water. Timer indicator will resume countdown after this.
- Timer may stop during heating step.
Timer indicator will not countdown until the machine reaches the
selected temperature .
- Timer may stop during spinning step.
Automatic unbalanced load detection system might be activated
due to the unbalanced distribution of the laundry in the drum.
Machine does not switch to spinning step when the laundry is not
evenly distributed in the drum to prevent any damage to the
machine and to its surrounding environment. Laundry should be
rearranged and re-spun.
Foam is overflowing
from the detergent
drawer.
- Too much detergent is used.
Mix 1 tablespoonful softener and ½ l water and pour into the
main wash compartment of the detergent drawer.
Laundry remains wet at
the end of the
programme
- Excessive foam might have occurred and automatic foam
absorption system might have been activated due to too much
detergent usage.
Use recommended amount of detergent
Part 8 : Problem & Solution
To Next Page
Loading...
