English 40
Attention!
Select the options before selecting the program main program
For some programs do not work together. (example: pre-wash program can not be combined
with the Quick Wash program).
- Prewash
Pre-wash function is only recommended for heavily dirty laundry. Without using this function,
you will save energy, water, detergent and time. For curtains and frilly kind of laundry pre-
wash function should be used without detergent.
- Quick Wash
This function is useful to shorten the washing time. Use this function to a small amount of
laundry or a mild degree of dirty laundry.
- Rinse Plus
This function makes it possible to add an extra rinse cycle of main laundry programs that
have been selected, and can minimize the residual detergent into the fabric. So the harm that
can be caused by residual detergent for sensitive skin (baby skin, allergies, etc.) can be
minimized.
- Rinse Hold
If you are not going to unload your clothes immediately after the programme completes, you
may use rinse hold function to keep your laundry in the final rinsing water in order to prevent
them from getting wrinkled when there is no water in the machine. Press Start / Pause /
Cancel button after this process if you want to drain the water without spinning your laundry.
Programme will resume and complete after draining the water. If you want to spin the laundry
held in water, adjust the Spin Speed and press Start / Pause / Cancel button. The programme
resumes. Water is drained, laundry is spun and the programme is completed.
- Time Delay
This function makes it possible to delay the start time up to 24 hours of leaching. The setting
can be made at intervals of 30 minutes. To activate this function can be done by following
these steps:
1. Press the "+" or "-" on the "Time delay" function to set the delay time as you wish.
2. Press the "Start / Pause / Cancel" to activate this function.
Attention!
During the delay period, insert and remove the laundry from the washing machine can still
be done.
- Resetting Time Delay
To reset time delay can be done by following these steps:
1. Press the "Start / Pause / Cancel".
2. Press the "+" or "-" on the "Time delay" functionto set the delay time as you wish.
3. Press the "Start / Pause / Cancel" to activate this function.
- Canceling Time Delay
To cancel the delay and start the wash program can be done by following these steps:
1. Press the "Start / Pause / Cancel"
2. Press the "+" or "-" on the "Time delay" function to reduce the time delay.
3. Press the "Start / Pause / Cancel" to start the wash program.
Attention!
When you select this function, load your machine with half of the maximum laundry specified
in the programme table.
- Time Display
The display screen will show the time needed to complete a wash program. Length of time may
be different from the consumption table / washing programs, this could be due to differences in
water stress conditions, room temperature, temperature and water content, the type and amount
of laundry, additional programs selected and the voltage available.
- Starting the Wash Program
For the selection of the program please follow the steps below:
1. Press the POWER button to turn on the washing machine power.
To Next Page
Loading...
