2. If LEVEL is patched and STEP is unpatched
○ Touch a Keypad to make it the active step
○ LEVEL is modulated by its input signal
○ Voice 1 frequency is set to the active step
3. If STEP is patched
○ A rising edge in STEP input signal advances to next step in
sequence
○ Touch a keypad to toggle a step on/off
○ When sequence reaches a selected step (50% LED brightness), the
sequence reverses after playing that step
○ If LEVEL is unpatched
■ LEVEL input is normalled to STEP input
○ If LEVEL is patched
■ LEVEL is modulated according to its input signal
○ Voice 1 frequency is set to the active step
STEP INVERT outputs an inverted STEP signal. If STEP is high, STEP INVERT is
low and vice versa. If nothing is patched in STEP input, STEP INVERT outputs
a high signal.
THRESHOLD outputs a high signal when the knob position for t
he active step
is past the noon position.
TOUCH outputs a high signal when any keypad is touched.
15
To Next Page
Loading...