Sequence 2
SEQUENCE 2 determines what frequency is played by VOICE 2.
The four steps of SEQUENCE 2 are played by patching a signal to the STEP
input.
The STEP input is normalled to Voice 2 LEVEL input.
When the DIRECTION input receives a high signal, SEQUENCE 2 will step in the
reverse direction when STEP receives a high signal.
If STEP is unpatched, SEQUENCE 2 will move to a random step when DIRECTION
re
ceives a high signal.
Randomization
When a step knob is turned full CW, the Sequencer outputs a random
note/frequency when that step is active. The randomization is based on the
knob position when the step was last active.
16
To Next Page
Loading...