MIDI
Pluto sends and receives MIDI data via the 3.5mm TRS MIDI jack and USB. To
connect a MIDI device to the MIDI jack, use a TRS/stereo 3.5mm cable or
TRS-to-MIDI DIN adapter. The MIDI jack is “Type A,” the official MIDI 2.0
spec.
MIDI in
Pluto receives notes on MIDI channel 1. When neither STEP input is patched,
the notes are sent to both voices. If a sequencer’s STEP input is patched,
then the MIDI input w
ill not be used for that sequencer’s respective voice.
MIDI input may also be used to set the scale/quantization for both voices.
See Scales.
MIDI out
Pluto sends MIDI notes from both Sequencers independently. Sequencer 1 sends
MIDI notes on channel 1. Sequencer 2 sends MIDI notes on channel 2.
When Sequencer 1 STEP is unpatched, the keypads send notes on MIDI channel
1.
Configuring MIDI channels
See Configurations for instructions on how to change the default MIDI input
and output channels.
23
To Next Page
Loading...