Configuration mode
Configuration mode is used to change MIDI channels, audio output mode, and
calibrate Pluto’s touch keypad.
Access configuration mode
● Power off Pluto
● Turn all knobs counterclockwise (to the left)
● Power on Pluto (without touching the touch pads)
● After LED startup sequence, Pluto will be in CONFIG MODE
Save or cancel changes
● Turn CLOCK knob to exit config mode and save any changed settings
● To cancel any
changes POWER off Pluto
Touch keypad calibration
● Use VOICE 1 knob to manually adjust touchpad sensitivity (CCW = more
sensitive, CW = less sensitive)
● Test the keypads. LEDs should light up when their respective keypads
are touched.
MIDI channels
Pluto accepts MIDI input on one channel and outputs MIDI from Sequence 1 and
2 to two channels
● Switch TOGGLE 1 to set MIDI IN channel: 1, 9, 14
● Switch TOGGLE 2
to set MIDI OUT channels: 1+2, 9+10, 14+15
Note: if toggle switches are not operated during CONFIG MODE, no changes
will take place
28
To Next Page
Loading...