19
PILOT BURNER GOES OUT DURING USE.
Insufficient gas supply pressure.
Defective gas tap or valve.
Defective thermocouple or insufficient heating.
Thermocouple incorrectly connected to gas tap
or valve.
Knob of gas tap or valve not pressedsufficiently.
THE MAIN BURNER DOES NOT LIGHT (EVEN
THOUGH PILOT IS LIT).
Insufficient gas supply pressure.
Blocked tubing or nozzle.
Defective gas tap or valve.
Defective burner (gas outlet holes clogged).
HEATING CANNOT BE ADJUSTED.
THE HOTPLATE DOES NOT HEAT.
THE APPLIANCE DOES NOT HEAT.
Temperature thermostat defective.
Heating elements defective.
Safety thermostat tripped.
HEATING CANNOT BE ADJUSTED.
Temperature thermostat defective.
REMINDERS FOR REPLACING COMPONENTS
SHUT THE GAS SHUT-OFF VALVE
AND/OR SWITCH THE APPLIANCE OFF
AT THE MAIN SWITCH INSTALLED
UPSTREAM.
AFTER REPLACING A GAS SYSTEM
COMPONENT, CHECK FOR GAS LEAKS
AT CONNECTION POINTS.
DISCONNECT THE APPLIANCE
ELECTRIC SUPPLY, IF PRESENT, BEFORE
CARRYING OUT ANY OPERATION.
AFTER REPLACING AN ELECTRICAL
SYSTEM COMPONENT, CHECK IT IS
CORRECTLY WIRED.
Remove the control panel.
Remove and replace the component.
Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE PILOT BURNER AND
THERMOCOUPLE.
Remove the control panel.
Remove the panstand grids and burners.
Remove the 3 screws securing the venturi to the
hob and pull the venturi out by approx. 10 cm.
Remove and replace the component.
Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE GAS TAP AND PIEZO IGNITER.
Remove the control panel.
Remove and replace the component.
Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE MAIN BURNER, PILOT BURNER,
THERMOCOUPLE AND IGNITER.
Remove the control panel and internal guards.
To Next Page
Loading...