RESEARCH AND DEVELOPMENT
11
To replace the cavity temperature probe, proceed as follows:
1) For machine models with door disassemble the door by unscrewing and removing the
screw of the hinge highlighted in the photo at the bottom of the machine. When the screw
has been removed, the hinge and relative pin will slip off without problems and
consequently the door as well.
For models with drawers pull the drawers from the machine.
2) Unscrew the screws at the back of the machine and remove the closing panel. Also
unscrew the 2 screws on the front of the appliance below the front control panel.
3) Unscrew the 2 screws blocking the control panel and disassemble the board as described in
the paragraph “replacing PC board” concerning failures and relative technical
interventions.
To Next Page
Loading...
