RESEARCH AND DEVELOPMENT
8
FAILURES AND RELATIVE TECHNICAL
INTERVENTIONS
Before proceeding with the intervention, make sure that the electric cable of the appliance
is unplugged.
Place the appliance on a flat and stable surface.
- REPLACING CAVITY HEATING ELEMENTS
To replace the cavity heating elements, proceed as follows:
1) For machine with door disassemble the door by unscrewing and removing the screw of the
hinge highlighted in the photo at the bottom of the machine. When the screw has been
removed, the hinge and relative pin will slip off without problems and consequently the
door as well.
For models with drawers pull the drawers from the machine.
2) Unscrew the screws at the back of the machine and remove the closing panel. Also
unscrew the 2 screws on the front of the appliance below the front control panel.
To Next Page
Loading...