RESEARCH AND DEVELOPMENT
13
7) Mount the new cavity probe placing the brass nosepiece between the brass threaded
closing fitting and the bush welded to the cavity.
8) Reposition the thermal insulation and close the machine by repeating the operations
described in points 1-2-3-4-5 in the opposite order.
- REPLACING HEATING ELEMENT PROBE
To replace the heating element probe, proceed as follows:
1) For machine with door disassemble the door by unscrewing and removing the screw of the
hinge highlighted in the photo at the bottom of the machine. When the screw has been
removed, the hinge and relative pin will slip off without problems and consequently the
door as well.
To Next Page
Loading...
