RESEARCH AND DEVELOPMENT
16
7) Reposition the thermal insulation and close the machine by repeating the operations
described in points 1-2-3-4-5 in the opposite order.
- REPLACING CORE PROBE (ONLY MODEL WTH 8 KEYS PC BOARD)
To replace the core probe, proceed as follows:
1) Disassemble the door by unscrewing and removing the screw of the hinge highlighted in
the photo at the bottom of the machine. When the screw has been removed, the hinge
and relative pin will slip off without problems and consequently the door as well.
2) Unscrew the screws at the back of the machine and remove the closing panel. Also
unscrew the 2 screws on the front of the appliance below the front control panel.
To Next Page
Loading...