Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 4
EEI-2714 TABLE
STEP 1:
Please put the Table Top (1) upside down on a carpeted or padded area.
Position 1 piece of Leg (2) into the corner of Table Top (1) as shown.
Insert 2 pieces of Bolt (A) with 2 pieces of Spring Washer (B) and 2 pieces of Flat Washer (C) into the pre-drilled holes on
bottom of Leg (2) through the pre-drilled holes on Table Top (1).
Repeat the same steps for the remaining Legs (2).
Use Open Wrench (D) to tighten Bolts (A) clockwise until secure.
STEP 2:
2
Hardware & Tool required
Ax8 Dx1
Bx8
Cx8
A
A
D
A
Carefully turn over the assembled table.
If you want to extend the table, slide the half of Table Top (1) apart as shown.
B
2
1
2
B
C
B
A
B
C
C
C
2
1
To Next Page
Loading...
