How to Adjust the M-Core 4 Series Temperature Limit Stop
Why Adjust the Temperature Limit Stop:
The water that comes out of your showerhead or tub spout is usually close in temperature to what you've set on your hot
water tank dial. In some areas of the country, this may be as high as 140°F/60°C. Showering at that high of a
temperature is not considered safe, it is generally not recommended to exceed 120°F/49°C ( This varies by State/
City). To maintain a safe showering experience,the Moen M-Core 4 Series is designed with a basic maximum
temperature out of 100 degrees. At the time of installation this may be adjusted up or down for maximum comfort. At any
time, this can easily be reset by following a few simple steps. The process below will explain how to modify the position
of the Temperature Limit Stop in your shower system.
Preparation:
• Recommended Tools: Straight Pick or
Flat Head Screwdriver, Pliers,
Thermometer
• We always recommend covering the
drain before beginning so as to not lose
any parts down the drain.
Video Instruction:
Video: M-Core 4 Series Installing a Tub Shower Video (The
segment on How to Adjust your Temperature Limit Stop begins
at the 6:12 point of the video).
Step 1: Remove the Lever Handle
Using a 3/32 Hex Wrench loosen the Set Screws under the
Lever.
Pull the Handle forward to remove.
https://solutions.moen.com/Article_Library/How_to_Adjust_the_M-Core_4_Series_Temperature_Limit_Stop
Updated: Fri, 28 Jun 2024 08:16:22 GMT
Powered by
1
To Next Page
Need help?
General
