-12-
Revision 2/F3506
IMPORTANT: THIS UNIT IS NOT
WATER PROOF.
DO NOT USE A WATER JET SPRAY TO
CLEAN INTERIOR OR EXTERIOR OF
THIS UNIT.
WARNING: ALWAYS TURN THE
POWER SUPPLY OFF BEFORE
CLEANING.
EXTERIOR
Clean with a good quality stainless steel
cleaning compound. Harsh abrasive cleaners
may damage the surface.
INTERIOR
Ensure that the oven chamber is cool. Do not
use wire brushes, steel wool or other abrasive
materials. Clean the oven regularly with a
good quality oven cleaner. Take care not to
damage the fan or the tube at the right side of
the oven which controls the thermostat.
OVEN RACKS
To remove, slide out to the stop position, raise
the front edge up, and lift out.
SIDE RACKS
To remove, take hold of the centre rung and
swing towards the oven top. To replace, hold
horizontally, engage in holes and swing down.
FAN BAFFLE
To remove, unscrew the oven lamp glass and
lift the baffle out. To replace, locate the
bottom edge of the baffle over the bottom
element terminal plate and secure in place
with the oven lamp glass.
4. MAINTENANCE
OVEN SEALS
To remove, hold at their centre point and
pull forward until they unclip. Remove side
seals first, then top and bottom. The seals
may be washed in the sink, but take care not
to cut or damage them. To replace, ensure
that the lip is facing the oven opening. Fit
the top and bottom seals first, then the side
seals.
OVEN DOOR GLASS
Clean with conventional glass cleaners
IMPORTANT: DO NOT OVER
TIGHTEN LAMP GLASS.
4.1 CLEANING
WARNING: ALL INSTALLATION AND SERVICE REPAIR WORK MUST BE CARRIED
OUT BY QUALIFIED PERSONS ONLY.
To Next Page
Loading...
