Revision 3/F3563
© Moffat Ltd, August 2006 E27 Convection Oven
-23-
Two Bolts
3) Uncrimp the retaining lugs of the window
spacer and remove the spacer and glass.
Retaining
Lugs
Figure 6.3.20
6.3.14 OUTER GLASS (E27)
1) Open the oven door.
2) Lock hinges into position by rotating the
hinge locking clip over the hinge locking
notch.
3) Lift door away from the oven and place on
a flat surface.
4) Undo three screws and remove the trim
from the bottom of the door. Carefully
withdraw the glass.
5) To replace, ensure that the two silicone
rubber seals are in place on the left hand
and right hand side of the door frame.
Clean the inside of the glass and refit it,
ensuring that the silicone rubber seals
cover the outer edges of the glass. Refit
the bottom trim, and fit the door to the
oven.
Figure 6.3.18
Three Screws
6.3.15 INNER GLASS (E27)
1) Remove the outer glass (refer 6.3.14).
2) Undo four screws and remove the top trim
and handle assembly.
Hinge Locking Clip
Hinge Locking
Notch
Figure 6.3.17
6.3.16 DOOR SEALS
1) Open oven door.
2) To remove, hold at their centre point and
pull forward until they unclip
3) Refit new seals.
Note:
Fit top and bottom seals first, with
open side of seal facing
downwards. Fit side seals with
open side facing outwards.
Figure 6.3.19
4) To replace, ensure the silicone rubber seal
has not been displaced. Clean the glass
and refit it. Place the window spacer in
position and crimp the retaining lugs over
to hold the glass in place. Refit outer
glass as above.
Four Screws
6.3.17 DOOR HANDLE (E27)
1) Remove the door (refer 6.3.14).
2) Undo four screws and remove the top trim
and handle assembly, taking care not to
dislodge the outer glass.
3) Undo two bolts securing handle to top
trim. Replace handle and reassemble in
reverse order.
Figure 6.3.21
To Next Page
Loading...
