www.mokosmart.com
Network status report period
Default: 10, range: 0 or 10-86400 (unit: second)
Value 0 means that the gateway will report the network
status only once when it successfully connects to the
server, and will not report it later.
2.5.4 Connection Timeout Option
The gateway will automatically reboot once when it connects to server exceeding the configured
timeout.
Default: 3, range: 0-1440 (unit: minute)
Value 0 means that the device will not reboot
2.5.5 Scan Timeout Option
When the scan switch is enabled, but no any data is scanned for a period of time, the gateway will
automatically reboot once.
Default: 60, range: 0-1440 (unit: minute)
Value 0 means that the device will not reboot
2.5.6 System Time
After the gateway is connected with the server, it will synchronize time from the NTP server every
1 hour. If the NTP server is invalid, it also supports to synchronize time from user’s phone.
The “Sync” button is used to require the UTC time from your phone, it also needs to select the
TimeZone to obtain the local current time.
To Next Page
Loading...