MX123 Connection System User Manual - AS-34566-001 74
STEP 7: Once the connector is removed, inspect for damage and grit. Additional
cleaning of the connector housing may be necessary. To avoid dropping
grit into terminal openings clean connector with the TPA facing the
ground. Using a clean damp (NOT DRIPPING WET) paper towel or rag,
brush off the heavy deposits. This effort should be directed at the
connector housing, not the TPA or terminal openings.
“Gritty” J2 Connector
DO NOT APPLY WATER TO TPA OR EXPOSED TERMINAL OPENINGS!
“Cleaned” J2 Connector
DO NOT WIPE HERE
CLEAN HERE
Section 11 (Appendix B): Cleaning Instructions
To Next Page
Loading...
