Page 20 of 24
BM03 - English - Molift Partner 230/255 - Rev. G/ 02/2008
Maintenance
Cleaning
Detergents must be pH-neutral. Do not use
solvents or strong liquids - this may damage
surfaces on the lifter and change the quality
of the material. For disinfection when need
-
ed; use isopropyl alcohol. Avoid abrasive or
etching cleaning products.
Clean surfaces with a damp cloth using an appropri-
ate detergent. Regular cleaning is recommended and
should accordingly be added to internal routines.
Inspection should be perfomed to uncover unexpect-
ed damages or errors.
Monthly inspection
Make sure that there is no damage or cracks
on supporting parts. The suspension shall
not be used if there are any visible damages
or cracks as it may cause personal injury or
damage to the lifter.
• Check the lifter, and the suspension especially,
for damage. Make sure there is no loose parts on
the lifter.
• Remove hair and pile from the castors and verify
that the castors rotates without abnormal friction
• Verify that the contacts of the hand control is
rmly in place, if necessary clean contact and
hand control with spirit or similar.
• Verify that the battery ts correctly in the battery
holder.
• Verify that the cables for the hand control and
charger are intact
• Run the lifter up and down, and legs in and out
to verify that it runs normally and without any
abnormal noise.
Periodic inspection
Molift recommends annual inspection according to
the checklist on page 22. The inspection is to be done
by an authorized service representative. The owner
of the lifter is responsible to ensure that one check-
list is lled out and signed for each inspection, and
for keeping the checklist.
Service
Molift Partner 230/255 has a LED on the battery
holder indicating if the lifter needs service. The LED
gives a green light when the lifter is ready for use.
The electronics registers how much the lifter is be-
ing used, and the load it is used with. After a given
time of use there will be a signal that the lifter needs
service to the service LED. The LED will rst give
a yellow light, then red. Take contact with your lo-
cal service representative and order service. If there
is a sound together with the light, it means the lifter
needs service immediately.
Service lamp Status
No light Power save
Green Ready for use
Yellow Order service, lifter
still works
Red Perform service
Red + sound Perform service im-
mediately
Service includes changing of plastic composite sus-
pension, changing and lubrication of brake and re-
placement of any worn or damaged part. Service is
done by an authorised service representative accord-
ing to procedures in the technical manual.
The service partner uses the Molift Service Tool to
read the data from the lifter, and for logging service
and resetting the service LED. The owner is respon-
sible to ensure proper logging and written verica-
tion performed by authorised service partner.
Service LED
To Next Page
Loading...
