Page 21 of 24
Troubleshooting
If you have access to other similar lifters, it might be
an advantage to “switch parts” in order to locate the
error. See the table for troubleshooting:
Symptom Possible cause/action
The lifting col-
umn is wobbly.
The lock handle is not locked
properly or the lifting column is out
of position in chassis / verify posi-
tion of lifting column and tighten
the lock
The lifter only
moves in one di-
rection/ adjust-
able legs only
moves in one di-
rection
Hand control has failed / test with
another hand control and change if
defective.
The control electronics has failed
/ change control electronics / con-
tact local representative for service
The lifter moves
uncontrolled /
adjustable legs
moves uncon-
trolled
Short circuit between hand con-
trol and lifter / clean the contact to
hand control with spirit to remove
grease
Hand control has failed / change
hand control / contact local repre-
sentative for service
Defective control electronics /
change control electronics / con-
tact local representative for service
The lifting arm
does not move /
adjustable legs
does not move
Emergency stop activated (button
is pressed in) / turn button counter
clockwise to reset
Battery is empty / change to a new
battery or charge battery
The motor connection is not in
contact / Reposition the lifting co-
lumn, use the allen key on top of
column and check the arrow to-
wards chassis (see page 7), cle-
an contact points on column and
chassis
The cable/contact to hand control
has disconnected / reconnect con-
tact
Hand control has failed / test with
another hand control and change if
defective / contact local represent-
ative for service
Defective control electronics /
change control electronics / con-
tact local representative for service
Motor is defective / change motor
/ contact local representative for
service
If you are not able to solve the fault or problems by
yourself using this manual, please contact local au-
thorised service representative. If you do not know
whom to contact locally, please contact your dealer
or Molift AS to get help.
Labelling
An informal label is placed on the column below the
batteryholder.
Manufacturer
Read user
manual
Maximum
load
Indoor use
only
Type B ap-
plied part
(IEC 60601)
Model name
Part number
and batch
number
Serialnumber
and year/week
of manufacture
Nominal
battery
voltage
To Next Page
Loading...
