5. TESTING AN ALARM ON MONIMOTO
1. Leave your Key Fob at home.
2. Switch o Bluetooth on your phone and close the Monimoto Application.
3. Take your Monimoto-equipped vehicle for a test ride outdoors.
4. In approximately 1 minute you should receive a call from Monimoto and soon after push
notifications should arrive to the App.
5. Open the App and check whether it is showing the precise GPS, WLS based or
approximate Cell ID (cell network triangulation location).
6. If you received precise GPS locations – use one of the exit alarm mode methods to
disarm the alarm.
7. If you received an approximate location please re-install your Monimoto in a dierent
spot on your vehicle or try again. Note: very tall buildings can reduce GPS signal strength
to the point of not being able to obtain precise locations.
8. Repeat the test ride until you get precise GPS locations.
15
To Next Page
Loading...
