Once your Monimoto has been successfully set up it will always be ON unless you specifically
switch it OFF or it runs out of batteries.
8. HOW TO SWITCH ON AND OFF MONIMOTO
IMPORTANT: Once a device has been switched OFF, the only way to
switch ON the device is by plugging in the USB-C charging cable to the
charging port for at least 1 second until you see blinking RED LED , it is
impossible to switch ON the device from the App or by pushing the reset
button, only plugging in the charging cable can switch ON the device.
TO SWITCH OFF YOUR DEVICE
1. Press and Hold the Reset button for 3 seconds -> reset button LED will display SOLID
BLUE then turn OFF.
2. Release the Reset button - > Device is now turned OFF.
TO SWITCH ON YOUR DEVICE
Follow the same steps for charging your device in Section 6.
1. Get a USB-C charging cable and adapter (not provided with Monimoto).
2. Remove rubber plug and insert USB-C charging cable into the charging port.
3. The device is now switched ON and should display the charging battery LED or full
battery LED.
IMPORTANT: If you do not release the button after Blue LED turns o
and continue to hold the reset button for 10 seconds or more, you may
accidentally reset the device to default as in Section 7 above.
18
To Next Page
Loading...
