Mooer LOOPER X2 - Maintenance and Software; Factory Reset and Firmware Updates

18
FactoryReset：
PowerOfftheLOOPERX2,thenpressandholdSAVEbutton,Thenpowerontheunittoresetittofactorysettings.All
datawillbeclearedafterfactoryreset.
FirmwareUpdate(Enterupdatemodemanually)：
YoucanconnectLOOPERX2toacomputerwiththeeditorsoftwareinstalledtoupdatethefirmware.Connecttheunitto
acomputerandselectfirmwareupdateinthesoftware,theunitwillthenbebootedtoupdatemode.Theinstructionsbelow
areforbootingtoupdatemodemanually:
●PowerOfftheLOOPERX2thenpressandholdbothfootswitches
●PowerOntheLOOPERX2
●The1-7LEDindicatorswillblinkchromaticallytoindicatebootingtoupdatemode
●ConnecttoacomputerviaUSBcable
●Opentheeditorsoftwareandtheupdatewindowwillpopup
●ClickonSTARTtobegintheupdate.DonotstoporpoweroffyourLooperX2oryourcomputerwhilethefirmwareisbeingupdated.The
updateshouldonlytakeafewminutes.