37
FILTERS (Continued)
LADDER MOD (ON/LIT, OFF/UNLIT)
When this button is lit, the EG AMT, LFO 2 AMT, and FM AMT knobs will
set the modulation for the Cutoff Frequency of the Ladder Filter. When
LADDER MOD is unlit, the knobs no longer adjust the Ladder Filter
modulation amount, but any previous modulations set for the Ladder
Filter will remain.
NOTE: The SVF MOD and LADDER MOD buttons can be On (lit)
simultaneously by pressing both buttons at the same time. In this case,
the EG AMT, LFO 2 AMT, and FM AMT knobs will affect the modulation
amounts for both Filters.
EG AMT (-10 to 0 to +10)
This knob sets the amount of control signal generated by the Filter
Envelope that will be applied as a modulation source to the Cutoff
Frequency of the selected Filter(s). In the center position, the EG AMT
knob will have no effect. Turning the knob to the right will increase the
amount of positive modulation being applied. Turning the knob to the left
will increase the amount of negative (or inverse) value being applied.
LFO 2 AMT (0 to 10)
The amount of modulation signal generated by LFO 2 that will be
applied to the Cutoff Frequency of the selected Filter(s) is determined
by this knob. At the far left setting, no modulation is applied. Turn the
knob to the right to apply more modulation signal.
FM AMT (0 to 10)
The amount of modulation signal generated by the FM (Frequency
Modulation) Source that will be applied to the Cutoff Frequency of
the selected Filter(s) is determined by this knob. At the far left setting,
no modulation is applied. Turn the knob to the right to apply more
modulation signal.
NOTE: The modulation source for the FM AMT knob is selected in the
Filter MORE page. An independent FM Source can be set for the Ladder
lter and for the SVF.
To Next Page
Loading...
Need help?
General
