Moons' SSDC-D Series - 2 Getting Started

6
Rev. 1.0
10/21/2018
SSDC-D/IP Hardware Manual
400-820-9661
2 Getting Started
The following items are needed:
• A 12-70VDC power supply, see the section below entitled
“
Choose a Power Supply
”
for
helping to choose the right one.
• A compatible SS or RS motor, please see the section below entitled
“
Recommended Motor
”
• A small flat blade screwdriver for tightening the connectors screw(included)
• A PC running Microsoft Windows XP/Vista/7/8(Using serial communication port. Prepare an
USB to Serial converter if the PC doesn
’
t have it.
• Install the Step-Servo Quick Tuner software
(download from MOONS website: www.moonsindustries.com )
• A power cable(included)
• Included a CAT5 cable, used to do the daisy-chain connection. It is also used to configure the
drive.
• Optional extended motor cable(Sold separately)
• Optional extended encoder cable(Sold separately)
• Optional extended I/O cable(Sold separately)