Moons' SSDC-D Series - Installing Software

7
Rev. 1.0
10/21/2018
SSDC-D/IP Hardware Manual
400-820-9661
2.1 Installing Software
Step-Servo Quick Tuner is the PC based software application used to configure, and perform
servo tuning, drive testing and evaluation of the step-servo products. System servo control gains,
drive functionality and I/O configuration are set with Step-Servo Quick Tuner. It also contains an
oscilloscope function to help set the servo control gains.
• Download the Step-Servo Quick Tuner from the MOONS
’
website and install it.
• Launch the software by clicking Start-----Programs ----MOONS
’
• connect the drive to PC by communication cable, configure the network on PC. Please see the
section below entitled
“
Connecting the Drive to Your PC using Ethernet
”
.
• Connect the drive to the Power Supply.
• Connect the motor to the drive.
• Power up the drive.
• Click the
‘
Ping
’
bottom, the software will recognize your drive, display the model and
firmware version and be ready for action.
The connectors and other points of interest are illustrated below:
SSDC-D, Modbus/TCP Communication type / SSDC-IP, EtherNet/IP Communication type
LED
Node ID
Ethernet communications interface
I/O Connector
Encoder Connector
Motor Connector
Power Connector