Moore Industries THZ3 - Section 5 - Configuration Using FDT;DTM Software

www.miinet.comMoore Industries-International, Inc.
- 75 -
User’s Manual
238-741-00K
May 2019
Programmable Smart HART Temperature Transmitter
THZ
3
/ TDZ
3
SECTION 5
Section 5 - Conguration using FDT/DTM
Software
Before reading this section on the FDT/DTM conguration, please read the Conguration
Overview at the beginning of Section 4 for general information on conguring the TDZ
3/
THZ
3
.
This section provides information on conguring the TDZ
3/
THZ
3
using a PC with PACTware
(an FDT frame application). For users who already have an FDT Frame Application, all the
following information is still relevant except for the PACTware installation. For more information
on FDT/DTM please refer to www.fdtgroup.org.
FDT Frame Application
Moore Industries has always provided manufacturer-specic programs to operate our eld
instruments to the full extent. TDZ
3/
THZ
3
will require the use of an FDT frame application, which
allows conguration and adjustment of any and all eld instruments ,which have a DTM. For
users who do not already have an FDT frame application, Moore Industries provides PACTware.
An FDT frame application, such as PACTware, is a PC program which interfaces with individual
software modules for instrument operation. This interface is regarded as the FDT; the individual
software modules for instrument adjustment are called DTMs (Device Type Manager) . This
conguration makes user-friendly adjustments possible because the interface for instrument
adjustment is optimally adapted to each instrument.
Furthermore, you can communicate with an FDT frame application not only via HART but also
via any standard eld bus system. Moore Industries provides a proprietary serial communication
DTM named MISP, which allows faster device conguration using our USB communication
cable. The MISP DTM will be provided in addition to the TDZ
3/
THZ
3
Device DTM. In the FDT
frame application, these individual instrument DTMs and communication DTMs are installed as
required.
FDT/DTM Software Installation
In order to get started you will need to either install the PACTware software and DTMs or just
install the DTMs (if you already have an FDT frame application installed). All the les you need
can be found on our website www.miinet.com.