What’s in the box?
Scout Robot
Charging Station
Adhesive tape (x2)
Type-C USB cable
Quick Start Guide
Lubricant for Mecanum wheels
Important note:
Scout doesn’t provide a power adapter. It is recommended to use a USB 2.0 Type A adapter
with 5V and >2A output. Some fast chargers with Type C output are NOT suitable for
Scout.
Place the charging station in an area with good lighting conditions to the floor or wall with the
supplied adhesive tape. Not recommended to stick the charging station to painted wood
flooring. Scout’s Mecanum wheels and docking to the charging station are optimized for hard
floor. Scout will not operate well on Hi-Pile or Shag carpeting.
Don’t remove the sticker underneath the charging station. If the charging station is too low,
it may not have good contact to the charging pins on the bot.
To Next Page
Loading...
