design new extension tools for Scout and add on to the extension
port. Explore the endless possibilities. For more details, please
refer to information on www.moorebot.com.
Getting Started
Place the charging station
Affix the charging station to the floor or against the wall using the
supplied adhesive tape.
To support patrol, it is important to make sure that the charging
station does NOT move around. If placing on carpeting it is
recommended to affix to the wall or baseboard using the adhesive
tape supplied.
It is also recommended to have at least 3 ft open space on each side
of the charging station, so that it is easier for the bot to navigate back
to its charging station with running into too many obstacles.
Plug the Type C USB cable into the charging station and into a 5V > 2A
USB adapter (not supplied).
Scout is capable of identifying its charging station within 6 ft range
and backing into it. Make sure that the charging station is placed
under good lighting conditions. During the night, Scout relies on its
own IR light source. The Battery Indicator reflects the charging
status.
Several tasks can only be performed when Scout is in the charging
station. These include software OTA (over-the-air) update, BIST
(built-in-self-test), the start of patrol, monitoring with motion detect,
and reboot.
Avoid heat sources or other battery-unfriendly conditions to place the
charging station.
To Next Page
Loading...
