Charge the Battery
Place the rear of Scout in the Charging Station making sure it’s in
contact with the charging pins.
You will see 4 blue flashing LEDs on the top of Scout and hear a tone
confirming Scout has connected and is charging.
All 4 LED lights will remain lit when Scout is fully charged. This may
take up to 3 hours to complete.
Powering Scout On & Off
Press the “On & OFF” button for 2 seconds until the Power LED lights
up. The system boots up. The power up process could take up to one
minute. There is a sound alert when the system is fully on.
Press and hold the button for 3 seconds to turn it off.
When Scout is turned off and is placed in the charging station, the bot
automatically boots up.
Important note:
Features that require Scout to boot up, such as OTA (Over-the-Air) update are
better to have the bot in the charging station. Otherwise, users must manually
power up the bot again.
Reset
To reset the robot, long-press the “RESET” at the rear of the robot
for >8 seconds. The robot restores the factory condition and turns it
off. This resets the password and unbinds the robot from the previous
user account.
To Next Page
Loading...
