EasyManua.ls Logo

Morco EUP11 - Default Chapter; Table of Contents

Morco EUP11
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
Gas Safety (Installation and Use) Regulations 1998
In the interest of safety, it is the law that all gas appliances are installed and serviced by a competent person in accordance
with the above regulations, building regulations, codes of practice and byelaws of the local water authority.
Failure to comply with the regulations may lead to prosecution. It is in your interests and that of your safety that the law is
complied with.
Related documents
The following British Standards, Codes of Practice and other Regulations must be observed in the installation of the water
heater.
The Gas Safety Regulations (Installation and Use) 1998
The Model Water Byelaws
Byelaws of the Local Water Undertaking
The Building Regulations (Permanent Buildings) England and Scotland.
BS 5482 Part 1 Installations in Permanent Dwellings
BS 5482 Part 2 Installations in Caravans and Non-Permanent Dwellings
BS 5482 Part 3 Installations in Boats
BS EN 1949 Installation of LPG System for Habitational Purposes in Leisure Accommodation Vehicles
BS EN 721 Leisure Accommodation Vehicles - Ventilation Requirements
BS EN ISO 10239 2008 Small Craft LPG Systems
CONTENTS
GENERAL SAFETY WARNINGS page 4
DESCRIPTION OF THE APPLIANCE page 4
1 OPERATION page 5
1. a Function page 5
1. b Usage page 5
2 TECHNICAL CHARACTERISTICS page 8
2. a Technical Data page 8
3 INSTALLATION page 9
3. a Regulations page 9
3. b Wall mounting page 9
3. c Room ventilation page 9
3. d Gas Connection page 9
3. e Water connection page 10
3. f Flue gas page 10
4 MAINTENANCE page 11
4. a Removing the casing page 11
4. b Troubleshooting: Problems and solutions page 11
FOR THE ENGINEER
Starting up the appliance and final checks page 12
WINTERISATION page 13
WARRANTY page 14
WARNING
This booklet contains information relevant to the user as
well as the installer.
When the product has reached the end of its
serviceable life, it shall be disposed of in an
environmentally friendly way and disposed of
according to the regulations in force.
Separate collection and recycling of the product
avoid negative impact for environment and health,
and allows recovery of materials, in order to obtain
energy and resources saving.

Related product manuals