GENERAL SAFETY WARNINGS
The User, Installation and Maintenance Manual is an integral part of the
product and so must be carefully preserved in order to accompany
the product; if it is lost or damaged another copy can be requested
from Morco Products Limited on 01482 325 456 or visit our website
www.morcoproducts. co.uk.
The installation of the device and any other repairs or
maintenance must be performed by a Gas Safe Engineer or
other qualified personnel according to the law in force, in
compliance with the installation regulations including any
revisions.
A Gas Safe Engineer or other qualified personnel must
commission this device.
The device must be used according to the manufacturer
specifications. The manufacturer cannot be held
contractually or otherwise responsible for damage caused to
persons, animals or objects as a result of incorrect
installation, repair or maintenance or improper usage.
The product’s safety or automatic regulation devices must
not be modified unless performed by the manufacturer.
This device is intended for heating water and therefore must
be connected to a water distribution network whose flow and
pressure are compatible with the product.
If water leaks are observed, turn off the water supply and
advise a Gas Safe Engineer or other qualified personnel.
If the appliance is not used for prolonged periods turn off the
gas supply. If there is a risk of the water freezing, empty the
water heater. Please see “frost and freezing” on page 5.
If the machine breaks down or does not function properly,
deactivate it, do not attempt to perform any repairs and
contact a Gas Safe Engineer or other qualified person.
The appliance should be maintained at least once a year.
When the product has reached the end of its serviceable life,
it shall be disposed of in an environmentally friendly way;
ensuring that the majority of the product is fully recycled.
When using the device the following safety rules must be applied:
Do not use the machine for purposes other than those
intended by the manufacturer.
Do not block the intake, flue or the ventilation openings in
the area where the device is installed with
rags, paper or any other materials.
If a gas leak is detected, do not switch on any electrical
devices, telephones or any other objects that could produce
a spark. Ventilate the area by opening the doors and
windows and switch off the gas supply.
Do not place objects on top of the device.
Do not leave flammable containers or substances in the
area where the device is installed.
Children or inexperienced persons should be prohibited from
using the device.
DESCRIPTION OF APPLIANCE
The Morco EUP11 is an open flued 11 litre instantaneous gas water heater. The air for combustion comes from the external
vents in the cupboard that the heater is placed in and hence very careful attention must be paid to providing sufficient
ventilation. See section 3.c. Room Ventilation. The appliance is suitable for use in dedicated boiler cupboards in caravan
holiday homes. We do not recommend this appliance for use outside of a dedicated cupboard or in boats, motorhomes or
rooms in which habitation takes place. The appliance relies on a pilot flame to ignite the main burner once a hot tap is
opened. The appliance does not store hot water. The flow of the water through the appliance can be adjusted from 5.5 to 11
litres per minute and this corresponds to the temperature of the incoming water being increased by 50°C or 25°C
respectively. This adjustment is made via the water temperature adjustment knob and during winter months it is advisable to
move the knob fully anticlockwise to ensure hot water of an acceptable temperature.
In parts of the manual the following symbols are used:
WARNING = for actions that require caution and adequate preparation
PROHIBITED = for actions that MUST NOT be performed
The water heater package contains:
2 Two knobs to attach to the control panel after
installation
1 Water filter to insert in the water valve pipe
fitting
To Next Page
Loading...
