13
To access again the display radio:
• First press the button and then twice the
Radio Test: Menu that allows to check if there is a proper transmission
between the display radio con and the stove. The test verifies if there are
other transmitting devices operating in the same environment.
When the function is activated, the display radio transmits continuously
(Tx) and counts all signals received (Rx) and missed (Er).
In the following example we have:
Tx = 624 (Transmissions from the display radio to the stove)
Rx = 611 (Successful receptions of the signal from the stove)
Er = 11 (Missed transmissions not intercepted by the stove)
In this example we have a very good signal quality.
Change Code: The change code allows the display radio to be
associated with a specific stove so that only one remote can operate it
(in this way more transmitting systems can operate in the same room). In
order to change the code:
• Highlight a new code in Change Code.
• Turn off the main switch of the stove.
• Press and keep pressed the SET button on the display radio,
while at the same time turn the main switch back on and verify
the out come of the operation.
If the word Tranfer Failed appears, repeat the procedure and select a
different code.
Thermostat Manage
Radio Test
Change Code
Set Contrast
Key Tone
Radio Standby
Radio
Standby
Set Contrast: Menu for adjusting the contrast on the display.
Key Tone: Menu for enabling or disabling the sound produced when
pressing a button.
System Menu
Menu to access the Secret Menu reserved for Technical Assistance
Centers. The access is PASSWORD protected.
Thermostat Manage
Radio Standby
Radio Test
Change Code
Key Tone
Set Contrast
Set
Contrast
+
15
-
Active
Gestione Termostat
Standby Radio
Test radio
Cambio Codice
Regola Contrasto
Toni Tasti
Key Tone
Enabled
Disabled
PASSWORD?
- - - -
Thermostat Manage
Radio Standby
Change Code
Set Contrast
Key Tone
Radio Test
Radio Test
Tx: 624
Rx: 611
Er: 11
Calibration
Monitor
Load
Clean
Language
Settings
Calibration
Monitor
Load
Clean
Language
Settings
Thermostat Manage
Radio Standby
Radio Test
Set Contrast
Key Tone
Change Code
Change
Code
999
1001
1002
1000
Calibration
Monitor
Load
Clean
Language
Settings
Calibration
Monitor
Load
Clean
Language
Settings
Calibration
Monitor
Load
Clean
Language
Settings
System Menu
To Next Page
Loading...
