Instruction Manual
MORSØ Mitring Machine
Model F
34
Lubrication Instructions
Approximately every two weeks lubricate:
The guides for
1. Knife block (4)
2. Slide Frame (10)
3. Cross (11) (lubricates simultaneously the forward movement of the knife block).
4. Linkage for the draw bar (40) of the knife block.
5. All the linkages in the lever system (46), incl. spring suspension.
Lubricant: Any acid-free oil.
Cleaning
MORSØ-F must be cleaned thoroughly after use.
Remove any waste wood from all the guides. (a ½” paint brush is ideal for this)
Remove the waste from the rebate support guides.
Remove the waste wood from behind the machine.
Resin from the mouldings can sometimes cause the knife blades to drag on the upward
action of the knife block. To remove this resin, use WD 40, sprayed onto a cloth made in the
shape of a ball (so that your fingers never go near the knives). Wipe in a downward action
only so that neither the cloth nor your fingers can come into contact with the cutting edge of
the knives.
Service F-1
To Next Page
Loading...
