Morso F - Rectifying Faults

Instruction Manual
MORSØ Mitring Machine
Model F
47
Faults Cause Repair
Incorrect cuttings Blunt knives Replace knives / Resharpen
See page F-2
Knives incorrectly installed Check the installation
See page F-2
Moulding with rebate burrs Rebate supports incorrectly
adjusted
Correct the adjustment
See page E-5
The moulding is not firm on the
table during cutting
Fences loose Fasten fences
See page E-3
Incorrect length measurements The length measure incorrectly
set
Correct the length measure
See page E-4
Stop beam loose Fasten stop beam
The basic position of the knife
block is changed
The height stop is displaced Correct the adjustment
see page E-7
The moulding is not cut quite
through
The forward movement is not
correct adjusted
Correct the adjustment
see page F-4
Rectifying Faults G-1